RCMANIA.cz

Kód: Vybrat vše

Version 1.10A
Changes since 2015-January-26
Corrections
• Restores functionality to the Wireless Trainer (WLT) system. 

Kód: Vybrat vše

Version 1.10
Changes since 2015-October-24
New Features & Improvements
• .All radios now have power-on branding showing the name in an easily-readable
form. In the past only DX18-level radios had this.
• In Multi Rotor models you may now assign trims to the sticks. The Trim/Channel
Config screen is available by selecting NEXT from the Trim Setup screen. You
may configure different trims per flight mode if you desire. Trim inputs are limited
to the trimmer inputs on each radio.
• Sound volume is adjustable using an analog inputs (sliders and knob).
• In Multi-Rotor models, you may now selectively enable trims for the gimbals
using the Trim Setup screen and selecting NEXT. Note that the trims can be
en/disabled differently for each flight mode, but the input device will be the same
for each mode.
• After 5 minutes of sounding the System Idle alert, the radio will automatically turn
off the RF transmission.
• If the transmitter battery voltage gets below 3.8V, the system will automatically
turn off RF transmission.
• Added status support for Xicoy, evoJet and Hornet ECUs (turbine telemetry).
Corrections
• In Sailplane model type, the L and R trimmers did not display the 2- or 3-position
status properly. They were blanks, although the roller would change them.
• The telemetry log file is now created properly again. The session headers are
now positioned correctly.
• Correctly exports and imports multirotor models with the “inside” and “outside”
warnings enabled.
• Altitude telemetry is now reported properly in audio for both imperial and metric
users, and visually on the Vario status screen which previously did not report
imperial negative altitudes properly.
• PowerBox Voltage and Capacity speech is now corrected. It had been spoken
10X what it should have.
• Some Italian, French, and German translations have been improved in Multi
Rotor model type and Telemetry sections. 
• In Multi-Rotor mode, Throttle Curves with only 3 points will now display and
function correctly.
• Telemetry for Turbine Fuel Remaining and Fuel Flow Rate are now properly
displayed and alarmed.
Audio System Changes
• .None. This version requires Sound version 1.08 for full compatibility. You
should download it from this link. You do not need to re-install this if you already
have it from an earlier update.