TRAXXAS píše:Hello
First try putting fresh batteries in the radio and in your vehicle. carefully inspect the battery contacts to make sure the batteries are making solid contact. Make sure the antenna on your receiver is not cut short, and that it is all the way out to the end of the antenna tube. Check the plugs in your receiver to make sure they are secure, that the steering is plugged into channel 1, the throttle servo is plugged into channel 2 and that none of the wires are pinched frayed or kinked.
Next reset your transmitter to its factory default settings. This procedure is different from the one in your Owners Manual.
Start with radio turned off.
Hold both menu and set.
Turn radio on
Release menu and set slow red blinking light
Hold menu and set till light changes to green blink
Release menu and set
While holding steering at full left, press set.
While holding steering at full right, press set.
Light changes back to red blink
While holding full throttle press set.
While holding full breaks, press set.
Light should now be solid green, factory endpoints reset has been finished.
Finally reset your transmitter to its default settings.
http://www.traxxas.com/node/17319Here is how to bind your transmitter to your receiver.
1. Install the AA batteries in the transmitter. Press and hold the SET button. Switch the transmitter on. The STATUS LED will flash. Release the button.
2. Press and hold the receivers LINK button. Switch the receiver on. The receiver LED will flash.
3. When both LEDs stop flashing (this will take just a moment or two), the system is bound and ready for use. Confirm that the steering and throttle operate properly before driving your model.
If it is still not working program the transmitter.
http://www.traxxas.com/node/17317All the programming videos are on this page.
http://www.traxxas.com/video/supportFinally unplug the steering servo from the receiver and see if the ESC programs normally. A shorted servo can cause the system to fail.
If it still does not work please try the following:
1. Unplug the iPod from the TQi.
2. Please make sure the Transmitter is bound and linked to a receiver.
3. Turn on the transmitter and receiver and verify you can drive the car.
4. Turn the transmitter and receiver off.
5. Plug in the iPod to the Transmitter and turn on just the transmitter.
6. Follow the upgrade instructions.
7. Then power off the transmitter, power it back up followed by the receiver they should link.
8. Proceed with an update to the receiver (if required).
Best regards,
Steve Lindholm
Traxxas Customer Service
.