RCMANIA.cz

Ahoj mohl bych použít na řízení toto servo?

http://www.hobbyking.com/hobbyking/stor ... ouse_.html

Original ma silu nejaky 3kg, na tvuj odkaz se nedostanu, takze porovnej a pokud souhlasi velikost, tak jo.

Nevidim parametry, takze vic ti nepomuzu.

BMS-620MG High Torque Servo (Metal Gear) 9.1kg / .15sec / 50g
The servo comes with a servo accessory package and is made with a heavy duty servo case, the servo is designed for R/C high performance Car applications. Double ball bearing with flexible rubber waterproof, otherwise the ourput spline is same with Futaba 25 tooth.
This servo comes with JR/Hitec S Connector also known as a "Universal Connector". Even thought this servo comes with JR/Hitec S Connectors, this servo is electrically compatible with Futaba receivers.
1. Metal gear
2. curve gear with smooth.
3. Double M9.6 ball bearing (si-oil)
4. 3 pole strong torque of motor with low signal affect and success get CE certification.
5. Rubber fitting case for waterproof
6. Same with Futaba 25 tooth spline
7. Heavy duty servo case

Weight: 50 grams / 1.78 oz
Dimensions: 40.5 x 20 x 42 mm / 1.60 x 0.78 x 1.62 inch
Torque At 4.8V: 9.1kg-cm , 126 oz-in
Torque At 6.0V: 10.6kg-cm , 144 oz-in
Speed At 4.8V: 0.15sec / 60 deg at no load
Speed At 6.0V: 0.13sec / 60 deg at no load

No nyslim ze bude stacit ale potrebuju to odklepnout od nekoho zkusenejsiho;-)

To budes mit azaz bohaty, takze bez problemu. Za predpokladu, ze je to standardni servo (40x20), to si zmer na originalu.